|
The USBG-DIONET series data gateways are designed to adopt your industrial serial devices to the Internet
instantly. It delivers simple, reliable and cost-effective network connectivity for multiple serial
devices. It address the need to connect individual RS-232 or RS-422/485 devices, such as PLC's, meters,
sensors, to an IP-based Ethernet LAN. It makes your application software to access serial devices
anywhere on a local area network or the Internet.
 |
Multi-port RS232/422/485 to Ethernet Data Gateway Features:
- Provides one RS232/422/485 Port over LAN
- Provides 7 Digital I/O Lines over LAN
- Allows to Reset the Hardware from External
- Supports 4-wire RS-422/485 and 2-wire RS-485 applications
- 300bps to 115.2Kbps Serial Port Baud Rate
- Built-in 15KV ESD Protection for ALL Signals
- Provides TCP Server, TCP Client, and UDP Modes
- Provides one 10/100Mbps, RJ45 LAN Port
- Provides +5V DC from DC Jack or Terminal Blocks
Read our documentation |
The USBG-DIONET provides 7 GPIO's (General Purpose Input Output) pins to provide extra digital I/O
control signals over Internet as well. A reset input port is designed to reset the whole
hardware of the USBG-DIONET. This feature is used to reset the USBG-DIONET if it is hang.
SPECIFICATIONS
LAN Port:
Ethernet: 10/100 Mbps, RJ45 connector
Protocols:
UDP, IP, TCP, ICMP, HTTP, DHCP, ARP-Ping
.
Serial Interface:
The Serial interface provides a DB9 RS-232 connector and a RS-422/485 terminal block connector.
You can only use either RS-232 or RS-422/485 (but not the same time).
The key benefits are:
-RS-232 Connector: DB9 male
-RS-422/485 Connector: 4-pin terminal block, 2/4-wire configured via DIP switch.
-Interface: 3 modes are selectable: 4-wire RS-422 (TXD+/-, RxD+/-).
2-wire RS-485 (TxD+/-, RxD+/-). 2-wire RS-485 (Data+/-, Data+/-)
-Parity: Parity: None, Even, Odd
-Data Bits:7,8
-Speed:300bps to 115.2Kbps.
-Terminator:120 OHM, can be Enabled/Disabled by DIP switch
-15KV ESD protection for all signals
-Provides wall and rack mounting holes
Digital I/O pins
7 Digital I/O pins for control applications. They are designed in terminal block connectors.
Reset Input
The reset input connector accepts the active signal from outside. If the signal was forced to low,
then the USBG-DIONET will reset all its hardware.
Power Requirements
+5VDC DC from Jack or from Terminal Block Connectors.
Environmental:
Operating Temp.: 0 to 55°C (32 to 131°F)
Storage Temp: -20 to 85°C (-4 to 185°F)
Operating Humidity: 5 to 95% RH
Form Factor: 5.98"(L)x2.76"(W)x1.06"(H) (15.20 x 7.00 x 2.70 cm)
|
|
